83
MAINTENANCE
FUEL AND OIL SYSTEMS
3
Oil Filters and Oil Reservoir
Perform visual inspections to identify oiling system
leaks. Make certain the oil tank is filled and oil
supply is not contaminated.
Evinrude E-TEC V model outboards are equipped
with two serviceable oil filters: one is located in the
oil injection tank, and one is located in the oil sup-
ply line before the oil lift pump.
Sample oil from bottom of oil injection tank. Con-
firm that oil is free of water or other contaminants.
Air Silencer
The air silencer on Evinrude outboards maximizes
air flow while minimizing noise.
Routine cleaning of the air silencer is recom-
mended to remove any accumulation of debris.
Hoses and Connections
Check condition of all hoses and connections in
both the fuel and oil systems:
• Visually inspect all components.
• Observe all clamps, hoses, and connections
while outboard is running.
• Replace all damaged components.
• Repair all leaks.
1. Filter, oil supply line
2. Filter, oil injection tank
005233
42785
21
005238
WARNING
Failure to check for fuel leakage could
allow a leak to go undetected, resulting in
fire or explosion.
To Next Page
Loading...
Need help?
General
