Need help?Do you have a question about the Evinrude E-tec 2011 Series and is the answer not in the manual?
Provides essential contact details for technical, warranty, and consumer support.
Details warranty claims process and requirements for North American dealers.
Outlines technical support, training locations, and technician certification requirements.
Details software, wiring harness, flywheel torque, and lower mount changes.
Covers changes to lower engine covers and oil pressure sensor retention.
Discusses SystemCheck warnings and engine overheat damage diagnosis.
Provides a 26-point inspection checklist for regular service intervals.
Addresses starter drive gear engagement issues and spark plug substitutions.
Details the latest software version, its capabilities, and minimum hardware requirements.
Explains the mandatory software registration and initial setup procedures.
Describes ICON rigging kits and conversion kits for digital shift/throttle control.
Provides advice on buss cable issues and connector assembly to avoid network problems.
Explains instancing for gauges and device association on NMEA 2000 networks.
Lists bulletins referencing specific I-Command issues and solutions.
Covers tiller handle kits and frequently requested part numbers for ordering.
Discusses causes of propeller shaft failure due to incorrect hardware and clamp load.
Introduces new tools developed for 2011 model year outboards, like the Fuel Flow Test Kit.
Details the kit for updating I-Command digital gauge software via DealerPort or BOSSWeb.
Lists paint color codes, spray can numbers, PPG codes, and applications for 2011 models.
Provides a chart of all available fuses, including P/N, type, amp rating, color, and dimensions.
Details EMM part numbers by model and year, with important installation notes.
Provides a reference to topics presented in previous Product Service Updates.
Provides essential contact details for technical, warranty, and consumer support.
Details warranty claims process and requirements for North American dealers.
Outlines technical support, training locations, and technician certification requirements.
Details software, wiring harness, flywheel torque, and lower mount changes.
Covers changes to lower engine covers and oil pressure sensor retention.
Discusses SystemCheck warnings and engine overheat damage diagnosis.
Provides a 26-point inspection checklist for regular service intervals.
Addresses starter drive gear engagement issues and spark plug substitutions.
Details the latest software version, its capabilities, and minimum hardware requirements.
Explains the mandatory software registration and initial setup procedures.
Describes ICON rigging kits and conversion kits for digital shift/throttle control.
Provides advice on buss cable issues and connector assembly to avoid network problems.
Explains instancing for gauges and device association on NMEA 2000 networks.
Lists bulletins referencing specific I-Command issues and solutions.
Covers tiller handle kits and frequently requested part numbers for ordering.
Discusses causes of propeller shaft failure due to incorrect hardware and clamp load.
Introduces new tools developed for 2011 model year outboards, like the Fuel Flow Test Kit.
Details the kit for updating I-Command digital gauge software via DealerPort or BOSSWeb.
Lists paint color codes, spray can numbers, PPG codes, and applications for 2011 models.
Provides a chart of all available fuses, including P/N, type, amp rating, color, and dimensions.
Details EMM part numbers by model and year, with important installation notes.
Provides a reference to topics presented in previous Product Service Updates.
General| Engine Type | 2-Stroke |
|---|---|
| Fuel System | Direct Injection |
| Cooling System | Water Cooled |
| Starting System | Electric |
| Cylinder Configuration | Inline or V-type depending on model |
| Steering | Remote |
| Shaft Length | Varies (e.g., 15", 20", 25") |
| Oil Injection | Yes |
| Warranty | 3 years |
| Ignition System | ECU-controlled digital ignition |
To Next Page