28
200 – 300 HP 90° V6 MODELS
Ordering Replacement Gearcases
The L2-Type gearcase with the0.58 (1.71:1) gear ratio is no longer available.
Use an M2-Type gearcase with the
0.54 (1.85:1) gear ratio if replacement is
needed.
Because a gearcase conversion kit is required, existing part numbers do not
supersede. Dealers who enter an order for a
0.58 gear ratio L2-Type gearcase
will receive an invoice with a “Note” to call the After Sales Service Department.
This will result in delays receiving the correct replacement gearcase.
Order the following parts:
• Select the correct M2-Type replacement gearcase.
Refer to the Parts Catalog for replacement gearcase part numbers.
• Select the correct gearcase conversion kit –
•order P/N 5008535, for 20 inch models.
•order P/N 5008536, for 25 inch models.
Gearcase conversion kits include the correct shift rod, a new exhaust grommet,
new gearcase mounting screws and installation instructions.
Refer to the installation instructions for the following:
• Exhaust grommet and Oetiker clamp installation.
• Shift rod installation and shift rod height adjustment.
• Correct water inlet screen selection.
• Correct trim tab selection and installation.
• Gearcase mounting screw torque.
• The change of gear ratio requires a change of propeller pitch.
M2-Type Gearcase
Gearcase Conversion Kit (Typical)
To Next Page
Loading...
