Evinrude E-TEC E150DSLSCR User Manual

228
POWERHEAD
POWERHEAD REMOVAL
POWERHEAD REMOVAL
Remove lower motor covers. Lower Cover
Removal on p. 91.
Remove flywheel cover and rear shroud.
Remove air temperature sensor from air silencer.
Remove the air silencer.
Disconnect power trim connectors.
Remove screw and washer from shift rod lever to
release the lower shift rod.
WARNING
Protect against hazardous fuel spray.
Before starting any fuel system service,
carefully relieve fuel system pressure.
Refer to Relieving Fuel System Pressure
on p. 183.
To prevent accidental starting while ser-
vicing, disconnect the battery cables at
the battery.
005248
005272
1. Tilt limit switch connector
2. Sending unit connector
005254
1. Tilt relay connector 005255
1. Shift rod screw 005253
2
1
1
1

Evinrude E-TEC E150DSLSCR Specifications

General

Horsepower	150 HP
Starting	Electric
Recommended Fuel	87 Octane
Oil Type	Evinrude XD100
Full Throttle RPM Range	5000-6000 RPM
Exhaust	Through Prop
Cooling System	Water-cooled
Fuel Induction	Direct Injection
Shaft Length	20 in
Oil Requirement	XD100 oil