Evinrude E-Tec User Manual

21
OPERATION
SAFETY INFORMATION ENGINE STARTING / STOPPING
Refer to the Pre-Ride Inspection on page 42.
Complete the inspection before using your
Evinrude E-TEC outboard.
You MUST supply water to the
engine before attempting to start it.
Engine damage can occur quickly.
Be sure the water intake screens are below
the water surface.
Engine Cut–off/Key Switch
A combination engine cut–off switch and key
switch is a feature of Evinrude prewired re-
mote controls and all Evinrude control wiring
kits. Use of the engine cut–off feature is highly
recommended on all boats.
Connect the clip to the engine cut–off switch/
key switch.
A DANGER
Serious injury or death can result from
contact with a rotating propeller or mov-
ing boat and outboard.
Propeller blades can be sharp and the
propeller can continue to turn even after
the engine is off.
Assure the engine and prop area is clear
of people and objects before starting
engine or operating the boat.
Be alert of people in the water.
Always shift the outboard to NEUTRAL
and shut off the engine immediately
when your boat is in an area where there
might be people in the water.
A DANGER
DO NOT run the engine indoors or with-
out adequate ventilation or permit
exhaust fumes to accumulate in confined
areas. Engine exhaust contains carbon
monoxide which, if inhaled, can cause
serious brain damage or death.
A WARNING
The engine cover is a machinery guard.
DO NOT operate your outboard with the
cover off unless you are performing
maintenance or emergency starting, and
then be careful to keep hands, hair, and
clothing clear of all moving parts. Con-
tact with moving parts could cause injury
A WARNING
Be familiar with the waters you are oper-
ating in. The gearcase of this outboard
extends below the water surface and
could potentially come in contact with
underwater obstructions. Contact with
underwater obstructions may result in
loss of control and personal injury.
1. Clip
2. Engine cut–off switch/key switch
3. Tether cord
DR6819
DR5592
A WARNING
Always use the tether cord when operat-
ing your boat to help prevent a runaway
boat and reduce the risk of personal
injury or death.
NOTICE

Evinrude E-Tec Specifications

General

Starting System	Electric
Trim System	Power Trim and Tilt
Horsepower Range	25 HP - 300 HP (depending on model)
Weight	Varies by model
Bore x Stroke	Varies by model
Displacement	Varies by model
Gear Ratio	Varies by model
Alternator Output	Varies by model
Shaft Length	15", 20", 25", 30" (depending on model)
Oil Injection	Yes
Warranty	3 years
Engine Type	E-TEC Direct Injection 2-Stroke
Fuel Type	Gasoline