EasyManuals Logo

Evinrude E-Tec User Manual

Evinrude E-Tec
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #41 background imageLoading...
Page #41 background image
39
SPECIAL OPERATING CONDITIONS
SHALLOW WATER
Gearcase damage can occur if the gearcase
is allowed to drag on the waterway bottom.
Use caution when operating in shallow water.
IMPORTANT: Impact damage is NOT cov-
ered by the outboard warranty.
UNDER TOW
Should you require a tow from another boat:
Shift your engine to NEUTRAL;
Tilt its gearcase out of the water;
Off-load all persons into another boat; and
Keep speed slower than planing speed.
WEEDY WATER
Weeds block water intakes and may cause
your outboard to overheat. Weeds on the pro-
peller create vibration and reduce boat speed.
When operating in weedy water, run at slow
speeds and in REVERSE frequently to clear
weeds from the propeller and water intakes.
Check the water pump indicator often.
If REVERSE operation does not clear away
weeds, SHUT OFF the engine. Remove
weeds from propeller area and water intakes
before operating at higher speed.
1. Tilt tube lubrication points (annually)
DR38798

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Evinrude E-Tec and is the answer not in the manual?

Evinrude E-Tec Specifications

General IconGeneral
Starting SystemElectric
Trim SystemPower Trim and Tilt
Horsepower Range25 HP - 300 HP (depending on model)
WeightVaries by model
Bore x StrokeVaries by model
DisplacementVaries by model
Gear RatioVaries by model
Alternator OutputVaries by model
Shaft Length15", 20", 25", 30" (depending on model)
Oil InjectionYes
Warranty3 years
Engine TypeE-TEC Direct Injection 2-Stroke
Fuel TypeGasoline

Related product manuals