Evinrude E-Tec User Manual

27
 OPERATION
Shifting
When shifting from FOR-
WARD to REVERSE or from REVERSE to
FORWARD, pause at NEUTRAL until the
engine is at idle speed and the boat has
slowed.
If the following directions are not suitable for
your boat’s control, see your Dealer before
proceeding.
With engine running and control handle in
NEUTRAL:
Side Mount Controls
Unlock the control handle by lifting the neutral
lock lever on the hand grip. Move the control
handle with a firm, quick motion, forward or aft
until it engages the forward or reverse gear
detent.
Binnacle Mount Controls
Move the control handle with a firm, quick mo-
tion, forward or aft until it engages the forward
or reverse gear detent.
Speed Control
After gear engagement, move the control
handle slowly in the same direction to in-
crease speed.
FUEL ECONOMY
Fuel economy can vary depending on boat
load, hull design, and throttle setting. When
boat reaches top speed, throttle back from
FULL SPEED to a lower throttle setting. You
will save fuel with a minimal loss of speed.
004854
005502
NOTICE
32°
32°
FORWARD
REVERSE
REVERSE
FORWARD
NEUTRAL
58°
35°
53°
35°
FORWARD
FORWARD
REVERSE
REVERSE
NEUTRAL
Typical Fuel Economy Throttle Range DR6472
1. Side mount control
2. Binnacle mount control
DR6506

Evinrude E-Tec Specifications

General

Starting System	Electric
Trim System	Power Trim and Tilt
Horsepower Range	25 HP - 300 HP (depending on model)
Weight	Varies by model
Bore x Stroke	Varies by model
Displacement	Varies by model
Gear Ratio	Varies by model
Alternator Output	Varies by model
Shaft Length	15", 20", 25", 30" (depending on model)
Oil Injection	Yes
Warranty	3 years
Engine Type	E-TEC Direct Injection 2-Stroke
Fuel Type	Gasoline