Evinrude E-Tec User Manual

47
 SERVICE
5) Start the engine and RUN AT IDLE
SPEED. Flush engine for at least five min-
utes. A steady stream of water must flow
from exhaust relief port of outboard.
7) Turn engine OFF. Leave the outboard in
vertical position long enough to completely
drain the powerhead.
FUSE
A blown fuse will not allow the engine to start.
Replace it with a fuse of the same rating. A
spare fuse is provided.
Fuse Replacement
Use only fuses of the same
rating. Your Evinrude E-TEC outboard
uses 10-amp fuses.
Remove engine cover. Install spare fuse in
place of failed fuse.
Detach fuse from plug by pulling down on fuse
connector clip. Install spare fuse in place of
failed fuse.
Failure to install cover
securely may cause electrical problems.
HULL FINISH
The condition of your boat’s bottom affects
performance. Marine growth or bottom paint-
ing may reduce speed and fuel efficiency.
For maximum performance, keep the boat’s
running surface clean by rinsing it with fresh
water and wiping it dry. Apply Evinrude anti-
corrosion spray to any surface subject to cor-
rosion, but avoid the anti-corrosion anode(s).
1. Flushing device
2. Stream of water
008499
NOTICE
1. Fuse
2. Spare fuse
002001
1
2
NOTICE

Evinrude E-Tec Specifications

General

Starting System	Electric
Trim System	Power Trim and Tilt
Horsepower Range	25 HP - 300 HP (depending on model)
Weight	Varies by model
Bore x Stroke	Varies by model
Displacement	Varies by model
Gear Ratio	Varies by model
Alternator Output	Varies by model
Shaft Length	15", 20", 25", 30" (depending on model)
Oil Injection	Yes
Warranty	3 years
Engine Type	E-TEC Direct Injection 2-Stroke
Fuel Type	Gasoline