Evinrude E-Tec User Manual

FREQUENTLY ASKED QUESTIONS
No dealer-scheduled maintenance for the first three years of normal recreational use? Really?
• Yes! BRP knows you want to spend your time out on the water, not servicing your Evinrude
E-TEC outboard. There are no valves to adjust, belts to service, chains to replace, or oil to
change. We do recommend pre-launch inspections of your outboard at each use and at reg-
ular intervals. Salt water applications require minimal additional inspections and lubrication.
What fuel octane is recommended for my Evinrude E-TEC outboard?
• Evinrude E-TEC outboards require a minimum octane of 87 (U.S.). Use of higher octane fu-
els is not harmful, but also not necessary.
What kind of oil does my Evinrude E-TEC outboard require?
• Any TC-W3RL oil may be used. The outboard can be programmed by your Dealer to run on
Evinrude/Johnson XD100 oil for lower oil consumption and reduced operating cost. Refer to
Filling the Oil Tank on page 17; see also Oil Requirements on page 16.
Do I need to mix oil into my fuel?
•No. Evinrude E-TEC outboards do not require any mixing of oil and fuel.
Where should I take my Evinrude E-TEC outboard for service?
• For repairs covered under warranty, you must take your Evinrude E-TEC outboard to an au-
thorized dealer. BRP-approved dealers and distributors have received the necessary train-
ing to properly service your outboard. Contact BRP for an authorized Evinrude E-TEC dealer
near you.
Can I order replacement parts and accessories for my Evinrude E-TEC outboard?
• Yes. When replacement parts are required, use Evinrude/Johnson Genuine Parts or parts
with equivalent characteristics, including type, strength, and material. Using substandard
parts could result in injury or product malfunction. Your dealer can order the parts and ac-
cessories you desire.
Do I need to complete any paperwork when I move or sell my Evinrude E-TEC outboard?
• Yes. In order to maintain contact with you or the new Evinrude E-TEC owner, BRP requests
you complete the form outlining Change of Address / Change of Ownership on page 77.
This will ensure you or the new owner is made aware of any product announcements and
keep the warranty coverage up-to-date.
What do I need to do before storing my Evinrude E-TEC outboard for the winter?
• Winterization is minimal. Refer to Storage on page 49 for step-by-step instructions to store
your Evinrude E-TEC outboard for the off-season.

Evinrude E-Tec Specifications

General

Starting System	Electric
Trim System	Power Trim and Tilt
Horsepower Range	25 HP - 300 HP (depending on model)
Weight	Varies by model
Bore x Stroke	Varies by model
Displacement	Varies by model
Gear Ratio	Varies by model
Alternator Output	Varies by model
Shaft Length	15", 20", 25", 30" (depending on model)
Oil Injection	Yes
Warranty	3 years
Engine Type	E-TEC Direct Injection 2-Stroke
Fuel Type	Gasoline