EasyManuals Logo

Evinrude E-Tec User Manual

Evinrude E-Tec
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #47 background imageLoading...
Page #47 background image
45
MAINTENANCE SCHEDULE
Routine inspection and maintenance is nec-
essary to prolong outboard life. The following
chart provides guidelines for inspection and
maintenance to be performed by an autho-
rized Dealer.
IMPORTANT: Outboards used in rental, com-
mercial, or other high hour applications re-
quire more frequent inspections and
maintenance. Adjust schedule for operating
and environmental conditions.
Description
Engine
Care
Product
Every 300
Hours or
3 Years
(1)
Anti-corrosion anodes
(2)
Electrical and ignition wires, inspect for wear or chafing
Engine to transom mounting hardware, re-torque (40 ft. lbs.)
Fasteners, inspect any loosened components
Fuel and oil system components, inspect and repair leaks
(3)
Fuel filter, replace
(4)
Gearcase lubricant, replace
A
Grease fittings, lubricate
(2)
C
Muffler foam, inspect, replace if necessary (40–90 HP models only)
Oil Filter, replace (V4 & V6 models only)
Power trim/tilt system and fluid level, inspect
B
Propeller shaft splines, inspect and lubricate
(2)
C
Spark plugs, inspect and replace if necessary
(3)
Starter pinion shaft, inspect and lubricate (electric start models only)
D
Steering system, inspect and lubricate
C
Thermostat and pressure valve, inspect
(3)
Throttle cable and shift cable inspect
Water pump, inspect or replace if necessary
(1) Average recreational use. Commercial use, heavy use, or use in salt or polluted water requires more
frequent inspection and maintenance (annual checks are recommended).
(2) Annually in salt water applications – Refer to Service on page 46.
(3) Emission-related component. Refer to Owner Responsibility on page 44, Product Warranty Information
on page 63 and, if applicable, California Emission Control Warranty Statement on page 66.
(4) Replace boat-mounted fuel filter annually. Refer to Boat-Mounted Fuel Filters on page 57.
A.
HPF XR Gearcase Lubricant
HPF Pro Gearcase Lubricant in high performance or commercial applications
B. Evinrude/Johnson Biodegradeable TNT Fluid
C. Triple-Guard Grease
D. Starter Bendix Lube ONLY, P/N 337016

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Evinrude E-Tec and is the answer not in the manual?

Evinrude E-Tec Specifications

General IconGeneral
Starting SystemElectric
Trim SystemPower Trim and Tilt
Horsepower Range25 HP - 300 HP (depending on model)
WeightVaries by model
Bore x StrokeVaries by model
DisplacementVaries by model
Gear RatioVaries by model
Alternator OutputVaries by model
Shaft Length15", 20", 25", 30" (depending on model)
Oil InjectionYes
Warranty3 years
Engine TypeE-TEC Direct Injection 2-Stroke
Fuel TypeGasoline

Related product manuals