Evinrude E-Tec User Manual

25
 OPERATION
5) Turn key switch ON.
6) From a secure position in the boat, pull
hard on emergency starting cord to start
engine.
Repeat procedure, if necessary, until engine
starts.
7) Refasten flywheel guard in place by push-
ing the three fastening tabs back onto the
fittings.
If equipped, snap tether cord to secure place
on clothing. Proceed immediately to nearest
landing for service.
A CAUTION
Keep everyone clear of your immediate
area when pulling on emergency start-
ing cord, especially behind you.
1. Fastening tabs
002023
1
A DANGER
Contact with a rotating flywheel can
cause severe personal injury. Use
extreme care in re-fastening the fly-
wheel guard on the fastening tabs. Keep
hands, hair, and clothing away from
coming in direct contact with rotating
parts.

Evinrude E-Tec Specifications

General

Starting System	Electric
Trim System	Power Trim and Tilt
Horsepower Range	25 HP - 300 HP (depending on model)
Weight	Varies by model
Bore x Stroke	Varies by model
Displacement	Varies by model
Gear Ratio	Varies by model
Alternator Output	Varies by model
Shaft Length	15", 20", 25", 30" (depending on model)
Oil Injection	Yes
Warranty	3 years
Engine Type	E-TEC Direct Injection 2-Stroke
Fuel Type	Gasoline