Evinrude E-Tec User Manual

29
 TILTING AND TRIM
Tilt Support
If you intend to leave the outboard tilted for a
period of time, engage the tilt support.
IMPORTANT: DO NOT use the tilt support
while trailering. Refer to Trailering on page
40.
Engage
1) Move the tilt/run lever to TILT position.
2) Tilt the outboard UP.
3) Flip the tilt lock lever down.
4) Lower the outboard until the tilt lock lever
rests solidly on the stern brackets.
Disengage
1) Move tilt/run lever to RUN position.
2) Tilt the outboard UP.
3) Flip the tilt lock lever up.
4) Lower the outboard to operating position.
1. Tilt lock lever – lock position
008520
1

Evinrude E-Tec Specifications

General

Starting System	Electric
Trim System	Power Trim and Tilt
Horsepower Range	25 HP - 300 HP (depending on model)
Weight	Varies by model
Bore x Stroke	Varies by model
Displacement	Varies by model
Gear Ratio	Varies by model
Alternator Output	Varies by model
Shaft Length	15", 20", 25", 30" (depending on model)
Oil Injection	Yes
Warranty	3 years
Engine Type	E-TEC Direct Injection 2-Stroke
Fuel Type	Gasoline