Evolve PROJECT BMX - Mounting Reflectors

REFLECTORS
MOUNTING REFLECTORS
1. Put the seat post mounted rear reector in the correct position by
loosening the screws of the rear reector bracket.
2. Make sure the rear reector is vertical and points straight toward the rear
of the bicycle.
3. Make sure there are at least 7.6CM (3") of clearance between the top of
the seat and the top of the red rear reector.
IT IS IMPORTANT TO CHECK AND ADJUST
THE POSITION OF THE REFLECTORS AS YOU
ASSEMBLE YOUR BIKE.
The reectors must always be vertical
(perpendicular to the ground) and pointed toward
the front and rear of the bike.
Make sure that the adjustment is correct as a nal
step in the assembly of your bike.
NOTICE
FOR YOUR OWN SAFETY, DO NOT RIDE THE BICYCLE IF THE
REFLECTORS ARE INCORRECTLY INSTALLED, DAMAGED OR
MISSING. MAKE SURE THE FRONT AND REAR REFLECTORS ARE
VERTICAL. DO NOT ALLOW THE VISIBILITY OF THE REFLECTORS
TO BE BLOCKED BY CLOTHING OR OTHER ARTICLES. DIRTY
REFLECTORS DO NOT WORK WELL. CLEAN THE REFLECTORS,
AS NECESSARY, WITH SOAP AND A DAMP CLOTH.
WARNING
/25
Your bicycle is supplied with a reector kit based on the requirements of your
region.
These are an important safety and legal requirement, and should remain securely
tted and in good, clean conditions at all times. Periodically, inspect all reectors,
brackets and mounting hardware for signs of wear or damage.
Replace immediately if damage is found.