ERROR CODES
The display can provide warning for failures. The codes will appear when an
error is detected.
ERROR ERROR DESCRIPTION ACTION
Note: please read carefully the description of the
error code. When the error code appears, please first
restart the system and check all connectors. If the
problem is not eliminated or error code appear that is
not listed here, please contact rideevolve.com
04 Throttle Fault
1. Check the connector and cable of the throttle are
not damaged and correctly connected.
2. Disconnect and reconnect the throttle, if still no
function please change the throttle.
05
The throttle is not back in
its correct position.
Check the connector from the throttle is correctly
connected. If this does not solve the problem,
please change the throttle.
07 Overvoltage protection
1. Remove and re-Insert the battery to see if it
resolves the problem.
2. If the problem still occurs, contact rideevolve.com
08
Error with the hall sensor
signal inside the motor
1. Check all connectors from the motor are correctly
connected.
2. If the problem still occurs, contact rideevolve.com
10,14,15
Protection temperature
has been reached
1. Turn off the system and allow the drive system to
cool down.
2. If the problem still occurs, contact rideevolve.com
21 Speed Sensor Error
1. Restart the system
2. Check that the magnet attached to the spoke is
aligned with the speed sensor and that the distance
is between 10 mm and 20 mm.
3. Check that the speed sensor connector is
connected correctly.
4. If the problem still occurs, contact rideevolve.com
/43
NOTICE
To Next Page
Loading...