HANDLEBAR
Adjust for comfort. Tighten bolts securely. Replace worn grips, making sure
they do not slip on handlebars.
CHAIN
Check frequently for damage or stretch, replacing when necessary. Lubricate
often, taking care to oil each link.
Keep tires inated to the pressure indicated on tire wall. A foot or frame pump
should be used. (DO NOT use unregulated pressure pumps.) Make sure tires
are properly seated on rims and check tire-beads.
SADDLE ADJUSTMENT
Adjust height and angle for comfort. Do not raise seat past the MINIMUM
INSERTION mark. Tighten the quick-release seat bolt until the seat cannot be
rotated in the frame.
TIRES
Check for cracks in paint around tube junctions periodically. They may
indicate a bent or cracked frame. Immediately replace a bent or broken
frame. Frame damage causes excess strain on other bicycle parts and is very
dangerous.
ALWAYS remove the battery when cleaning. Use soapy water or water
mixed with a gentle detergent, and then rinse with clean water. Make sure all
electrical components are wipe clean and dry from any water or moisture.
REFLECTORS
Reectors should be mounted on the front fork, rear of seat, pedals and
spokes. Damaged units should be promptly replaced.
FRAME
CLEANING
Replacement batteries and chargers are available
and can be purchased separately. Please call our
Customer Service Department.
NOTICE
DO NOT USE HIGH PRESSURE WASHER OR SPRAY WATER
UNDER HIGH PRESSURE TO CLEAN BIKE. PRESSURE WASHING
CAN FORCE CONTAMINANTS INTO PARTS WHICH CAN LEAD TO
CORROSION, DAMAGE OR ACCELERATED WEAR.
/45
To Next Page
Loading...