EXFO FPM-600 - EXFO FPM-600;FLS-600 Getting Started Guide; Powering the Unit On and Off

FPM-600/FLS-600 10
3
Getting Started
Turning the Unit On and Off
When you turn off the FPM-600, it saves the current wavelength, unit
and reference power. It also saves the Hold Min/Max power mode if
activated.
Note:
Offset nulling values are always returned to factory settings.
To turn on the unit:
Press . The unit displays EXFO Inc. for a few seconds. You may use it
immediately under normal conditions.
To turn off the unit:
a few seconds.
IMPORTANT
If you remove batteries (and the AC adapter is unplugged), the unit
will turn off without saving the above values.
If batteries are low (and the AC adapter is unplugged), the unit will
save the above values and turn off.
From normal operating mode, hold down
WARNING
When the ACTIVE LED on your unit is on, the laser source is active
and emitting light. Do not look directly into a live fiber, and ensure
that your eyes are protected at all times.