FPM-600/FLS-600 20
Measuring Power or Loss (FPM-600)
Setting Power Correction Factor
5. Edit the correction factor as follows:
5a. Hold down a few seconds. The first digit of the CF blinks.
for a few seconds.
5b. Clear all digits by holding down
AND/OR
Select a digit to change by holding
increase its value by pressing
5c. While a digit blinks, hold down
until it blinks, then (it
returns to 0 after 9).
for a few seconds to save the
modified value (it remains in memory even when you turn off the
unit) or press to return to the previous value without saving.
6. Press twice to exit setup menus.
To Next Page
Loading...
