Frequency Tests
MaxTester Copper Test 187
WB Attenuation
WB Attenuation Threshold Settings
The Threshold Settings page allows you to set the
WB Attenuation threshold values for the test.
Attenuation sets up the good attenuation
threshold parameters.
Type is the threshold limit: either Maximum or
Minimum.
Enabled is a flag to use the current threshold:
either Yes or No.
To set threshold values:
1. Press the up/down arrow keys to highlight the
desired parameter.
2. Press the left/right arrow keys to view and select the options.
OR
3. Press on a value to open a list box of options or the alphanumeric
editor screen and use the navigation keys to scroll through.
4. Press to confirm the value.
To Next Page
Loading...
