MaxTester Copper Test 13
3 Getting Started with the
MaxTester
Turning the Unit On/Off
When you turn the unit on, you may use it immediately under normal
conditions. When the unit is turned off, it keeps the following parameters
in its internal memory:
Setup including application settings, phone and cable books, and test
lead characteristics.
Profiles consisting of:
Test parameters
User-defined thresholds
Note: Save the current profile before turning the unit off, or else any changes are
lost. See Save Profile page 29 for more information.
Regional, LCD, and energy-saving settings
Test results saved internally vs. USB
There are two ways to turn off the MaxTester
Suspend: the next time you turn your unit on, you will quickly return to
your work environment.
Shutdown: completely cuts power to the unit; the unit will perform a
complete restart routine the next time you use it. You should perform a
shutdown if you do not intend to use your unit for a few hours or more.
To turn the unit on:
Press to start. The unit initializes for a few seconds and displays the
Home pane.
To Next Page
Loading...
