What to do if my Exmark Lawn Mower does not drive?
If your Exmark Lawn Mower doesn't drive, ensure the drive release handle is in the operating position. Change the drive or pump belt if it is worn, loose, or broken, or if it is off a pulley. Replace the idler spring if it's broken or missing. Add hydraulic fluid to the reservoir or allow it to cool down if the hydraulic fluid level is low or too hot.
Why won't the clutch engage on my Exmark Lawn Mower?
If the clutch on your Exmark Lawn Mower will not engage, replace the fuse. Check coil resistance, battery charge, charging system, and wiring connections, replacing if necessary, if there's low voltage supply at the clutch. Replace the clutch if the coil is damaged. Repair or replace the clutch lead wire or electrical system and clean connector contacts if there's inadequate current supply. Remove a shim or replace the clutch if the rotor/armature airgap is too large.
What causes abnormal vibration in my Exmark LAZER Z Lawn Mower?
If your Exmark Lawn Mower exhibits abnormal vibration, here's what you can check: * Bent or unbalanced cutting blades can cause vibration, so install new cutting blades. * A loose blade mounting bolt can also be the culprit, so tighten it. * Check the engine mounting bolts and tighten them if they are loose. * Also, make sure the engine pulley, idler pulley, or blade pulley are not loose and tighten if necessary. * Install new belt.
Why does my Exmark LAZER Z pull left or right?
If your Exmark Lawn Mower is pulling to the left or right, it might be due to incorrect tire pressure in the drive tires. Adjust the tire pressure to correct this.
What does it mean when the oil temperature light is on and engine RPM is low on my Exmark LAZER Z?
If the oil temperature light is on and the engine RPM is low on your Exmark Lawn Mower, the Engine Control Unit may have limited engine RPMs, known as “limp” mode. Check the oil level. Remove debris from hood and oil cooler. Verify fan is operating.
Why is my Exmark LAZER Z Lawn Mower not driving?
If your Exmark Lawn Mower machine does not drive, here are potential causes: * The drive release handle might not be in the operating position; position it correctly. * A worn, loose, or broken drive or pump belt can prevent driving; change the belt. * If the drive or pump belt is off a pulley, change the belt. * A broken or missing idler spring can also cause this issue; replace the spring. * Low or excessively hot hydraulic fluid can be the problem; add hydraulic fluid to the reservoir or let it cool down.
General| Engine Brand | Kawasaki |
|---|---|
| Transmission | Hydrostatic |
| Deck Construction | Fabricated or welded steel |
| Category | Commercial |
| Type | Commercial |
| Speed | 10 mph |
| Turning Radius | Zero-turn |
| Fuel Capacity | 10-15 gallons |
| Weight | 1, 465 lbs |
Outlines essential safety practices for operating the machine.
Explains the importance and meaning of safety decals on the machine.
Provides critical instructions for safe operation on slopes.
Covers operation of ignition switch, brake lever, and PTO switch.
Essential safety and operational checks before starting the engine.
Critical safety rules to follow while operating the mower.
Warnings about operating with the ROPS and its proper use.
Detailed steps for safely starting the engine.
Procedures for engaging and disengaging the power take-off.
Critical safety rules to follow before and during maintenance.
A table outlining maintenance tasks by service interval.
Common causes and solutions when the starter fails to crank.
Troubleshooting common engine starting and running problems.
Wiring diagrams for various engine and control configurations.
Diagram illustrating the machine's hydraulic system components.
To Next Page
