Rear
side
Supporting
Hooks
Water
adapter
Axle
adapter
7.5 Re-assembling the coffee group in place
To place the espresso group back in place, make sure that on the front side of the espresso group,
the mark on the group’s axle, match the
outer triangle symbol . This is the normal
“wait” position of the group in the
machine. When the machine is working
normally, the adapter to the group will
be waiting for the group in this position.
When placing back in place the espresso group, begin by (1)
inserting the axle of the group in the axle adapter. Once this
axle line up with the adapter axle, proceed to insert the (2)
water connection of the espresso group to the machine.
7.6 Cleaning the group
First, dismount the espresso group from the machine as explained in this manual. Then proceed to
clean it up with neutral detergents (avoid solvents that could damage paint or plastics). Disinfectant
products as Chlorine-detergents are preferred.
The producer declines all responsibilities due to the use of caustic/aggressive detergents.
Loose the screw shown on the picture as to open the easy - access to cleaning the group.
1
2
Rear
side
To Next Page
Loading...
