Brilliance Manual
Page 5
2.2 Rear side &Open door view
3 MACHINE INSTALLATION
3.1 Suitable locations
This distributor is not suitable for outdoors service.
The machine must be installed in dry locals, and should not be cleaned projecting water against it.
Machine should not be exposed to temperatures under 1ºC.
When installing the machine near a wall, make yourself sure that the door can be wide open and
ensure yourself as well, that the fan’s grill at the right side of the machine, is not covered.
Don’t ever cover the machine with plastic film or cloths.
3.2 Water connection
After unpacking the machine and placing the machine in its final location:
Level the machine by turning its rotating feets.
Connect the machine to a water inlet of drinkable water. We recommend to have a valve to cut the
water to the machine if necessary. Pressure arriving to the machine should be between 1,5 and 8
bars.
Make sure that the water hose not are kinked anywhere when machine is
pushed into place.
Note: It is advised, to split some water out of the water outlet being used, as to let possible dirt out
of it.
Water inlet
Electric inle
To Next Page
Loading...
Need help?
General
