Expobar BRILLIANCE - D Oses a Djustment T Ime S Cheme

Brilliance Manual
Page 10
Now it comes the adjusting of the soluble ingredients. The quantity of soluble powder that will be
added to the actual recipe. Two canisters are available. Soluble time 3&4 are not used in this
machine: keep them set to 0. Each amount of product is set by increasing (pressing “+”) or
decreasing (pressing “-“) the time during which the soluble is added.
Finally we have to set the delay with which the solubles will be brewed. With buttons “+” and “-“
adjust the desired value; with “enter” we would begin adjusting parameters of button “2”. With
“Canc” we would come back to the superior menu.
5.6 Doses Adjustment Time Scheme
Each one of the 8 selections can be adjusted, modifying the following parameters:
5.7 Doses recommendations (examples):
On an attached document, different adjusting sets will be found depending on the country.
Note: Set the times as for the soluble ingredients to stop always around 1 second before the stop of
the pumping of water.
Set as well the mixer to work always around 2 seconds longer than the stop of the water and/or the
soluble ingredients. Not respecting this rules, will cause the mixer to clog.
Enter
Soluble Delay
Key 1 #.# s.
Canc
Enter
Soluble Delay
Time 1 Water 2 Pause Water 2 Time 2 Water2
Wate
Solubl
e Delay
Soluble time
Soluble
Time 1 Water 1 Pause Water 1 Time 2 Water1
Wate
Mixer Time
T
BEFORE
SOLUBILE
AFTER SOLUBLE
Brewing coffee
AFTER
Brewing coffee
BEFORE
Coffee Water Vol
Coffee Water Vol
Mixer Ti
m
e2 = 0
Mixer Time2
>
0

Soluble Time 3
Ke
y
1 #.#
Enter
Soluble Time 4
Ke
y
1 #.# s.
Canc
Canc
Enter
Enter
Soluble Time 1
Key 1 #.# s.
Soluble Time 2
Key 1 #.# s.
Enter
Enter
Canc
Canc
Soluble time 1
Soluble time2