Programming Menu
7
Use the arrow buttons to scroll to a reading, and then press F3
✔ to select or
deselect the reading. Three readings must be selected at all times, otherwise
an error message will appear. You must deselect a reading, when three are al-
ready selected, before you can select a new one.
Press F2 (UNIT), to change the unit of measure for the selected reading.
Press F1
to return to the main menu.
7.2 Functions Menu
In the Functions menu you can configure low and high Alarms, turn the Alarms
ON/OFF, and initiate meter-to-PC communication, after connecting the
RH600 to a PC using the supplied USB cable. Use the arrow buttons to scroll.
Press F3
✔ to open or select an item. See Section 9, Alarms, and Section 10,
PC interface, for details.
Figure 7.3 Functions menu. Set Low/High Alarm Limits and switch the Alarm function ON/
OFF. Initiate meter/PC communication after connecting the meter to the PC using the sup-
plied USB cable.
#NAS100113; r. AA/87024/87024; en-US
13
To Next Page
Loading...
Need help?
General
