Programming Menu
7
7.5 Settings Menu
In the Settings menu you can set the displayed language, auto power off
(APO) time, display brightness, date/time, and keypad tone ON/OFF. You can
also view the meter firmware version (see Section 10.3 for firmware update in-
formation). Press F3
✔ to open and to change a setting. Additional informa-
tion below.
Figure 7.6 Settings menu.
• Language selection: Press F3 to select a language.
• Auto Power Off (APO) time: Press F3 to set the APO time to OFF, 10, 15,
20, 25, or 30 minutes. Note that APO is disabled while the Data Logging is
running. The APO function will be enabled automatically when the Data
Logging stops recording.
• Display brightness: Press F3 to select the brightness level from 1 (dim-
mest) to 10 (brightest).
• Date/Time setting: Use the navigation arrow buttons to set the Year, Month,
Day, Hour, and Minutes. You can also select 12 or 24 clock modes. When
12 hour clock mode is selected, the display shows AM or PM after the time.
• Keypad tone ON/OFF: Press F3 to set the keypad tone ON or OFF.
#NAS100113; r. AA/87024/87024; en-US
15
To Next Page
Loading...
Need help?
General
