AvediaStream e2635/e3635 and e2655/e3655 Encoders V1.1
Administrator’s Guide 11
7. Configuring Encoding Options
The device starts encoding automatically when an appropriate source is connected. Some
aspects of the encoding can be configured if required. The encoder starts streaming
(transmitting an MPEG transport stream on the IP network) automatically when an appropriate
source is connected. Some aspects of the stream can be configured if required. For more
information refer to Encoding and Streaming on page 32 and to Stream Properties on page 47.
8. Configuring Test Patterns and Overlays
Specify solid colours/test patterns and/or logo and text overlays if you want to either carry out
system testing using common test patterns or add logos and text overlays to be displayed
continuously or when no signals are present at the input of the encoder.
For more information refer to Test Pattern on page 42.
9. Configuring Channel Announcements
The encoder uses SAP (Session Announcement Protocol) to announce its stream (channel) to
receiving devices. Included in the announcements are the name of the channel and the
multicast address and port on which the stream is sent. This is done automatically once the
encoder is up and running.
You can configure channel announcements to suit your requirements. For more information
refer to Channel Announcements on page 47.
10. Checking Status
You can check the operating status of the encoder and that the encoder is transmitting data at
the rate expected by the streaming settings. For more information refer to Status Monitoring on
page 52.
To Next Page
Loading...