39
4.4 DAY/NIGHT MENU
The day-night temperature function allows to start and switch OFF in automatic way the
equipment according to the two temperatures selected. After selecting the “DAY-NIGHT” menu
press the menu button 2(2) to scroll the following submenus(see figure 1 pag. 5):
Par. Display Description Settable values
1 Day night Enables/disables the day/night function ON/OFF
2 Day start Start of the day range/end of the night range From 00:00 to 23:50 at intervals of 10'
3 Day End End of the day range/Start of the nigh range From 00:00 to 23:50 at intervals of 10'
4Max temp. day Max temperature day range From 0°C to 35°C
5 Max temp. night Max temperature night range From 0°C to 35°C
When the stove goes into switching OFF due to temperature reached on the display appears the
blinking message “DAY-NIGHT OFF”
. The stove shall restart automatically when the ambient
temperature lowers of 3 °C compared to the max temperature which has been set.
Es. Status of the stove
➠ DAY-NIGHT OFF
Max temperature which has been set ➠ 25°C
When the ambient temperature lowers under 22°C (25 – 3 = 22 °C) the stove restarts automatically.
4.5 PELLET ADJUST MENU
In case the stove shows problems of operation due to the quantity of the pellets you may proceed
directly from the commands panel to the adjustment of the pellets load.
The problems connected to the quantity of fuel may be divided into 2 categories:
1- LACK OF FUEL
:
• the stove never manages to develop a suitable flame; it tends to remain always low also with a
high power.
• at the minimum power the stove tends almost to switch OFF bringing the stove to alarm “NO PELL“
• when the stove displays the alarm “NO PELL” there may be some unburnt pellet inside the furnace.
2- FUEL EXCESS
:
• the stove develops a very high flame also with low power
• tends to dirt a lot the panoramic glass obscuring it almost totally
• the furnace tends to encrust obstructing the holes for air suction due to excessive pellet load
because it is burnt only partially.
N.B. if the problem occurs only after some months of work, verify that the routine cleaning,
indicated on the stove booklet, have been performed correctly.
The adjustment to be performed is of the percentage type, then a modification on this parameter
involves a proportional variation on all the loadings speeds of the stove.
To access to the percentage adjustment of the pellet load it is necessary to select the item “ADJUST
PELLET” and press the menu button 2(2) .
On the display it shall be displayed the value
“00”: through the keys 4 and 5 you may adjust the
percentage increase/decrease desired from 5 points to 5 points (the parameter may be varied
with a maximum excursion from –50 to +30). Once the adjustment is performed, press the but-
ton
1 to confirm and exit.
To Next Page
Loading...
Need help?
General
