IN1606 and IN1608 Series Scaling Presentation Switcher • Operation 26
To open the OSD menu:
1. Connect a display device to an HDMI output connector (see figure 11,
B
on page 16).
2. Press the Menu or Enter button to open the OSD menu.
To navigate the OSD menu:
1. Press the Up or Down button to navigate the nine submenus. The table on page 25
shows the nine submenus and their respective submenu items.
2. Press the Enter or Right button to access the submenu items of the selected
submenu.
3. Press the Up or Down button to navigate the available submenu items.
4. Press the Menu button to return to the list of submenus.
To adjust a submenu item:
1. Navigate to an adjustable submenu item and press the Enter or Right button to select
the submenu item.
2. Press the Left or Right button to adjust the setting or select a specific adjustable
setting within the selected submenu item.
If the selected submenu item has multiple adjustable settings, press the Up or Down
button to select a value.
3. Press the Enter button to accept the new value.
Press the Menu button to cancel any pending changes.
To exit the OSD menu:
From the list of submenus, hold the Menu button for 3 seconds to exit the OSD menu.
To Next Page
Loading...
Need help?
General
