Extron electronics TLS 520M - Page 26

Room Scheduling System • Room Agent Installation and Configuration 20
General Settings window
The General Settings tab on the Device Management window (see figure 16) provides a
set of tools for managing display, time, and audio settings of the connected panel.
6666666666
77
77777777
88
88888888
22
22222222
33
33333333
44
44444444
55
55555555
11
11111111
Figure 16. Device Management Window, General Settings
1
Display Brightness — Set the panel illumination brightness, from 0 to 100 (percent)
using this fader control.
2
Display Sleep Mode — Toggle Sleep mode On and Off by selecting the appropriate
radio button. If Sleep mode is On, use the Minutes field to specify between 1 and 99
minutes.
3
Timezone — Use the drop-down list to select the appropriate time zone.
4
Synchronize Clock with — Toggle the clock synchronization source between the
Calendar server and NTP (Network Time Protocol — a networking protocol for clock
synchronization between computer systems) by selecting the appropriate radio button.
NOTE: If you select NTP, specify the path to the NTP server in the Server path:
field (
5
).
5
Server path: (available only if NTP is selected in
4
) — Specify a path for the NTP
server.
6
Audio Volume — Set the panel audio volume, from 0 to 100 (percent) using this fader
control.
Once you have made all desired changes available from the General Settings tab, click
either the OK button (
7
, the Device Management window closes) or the Communication
Settings tab (
8
, then communication settings are displayed, see figure 15 on the
previous page).