FAAC 400 Series - Table of Contents

400 1 732871 - Rev. D
Translation of the original instructions
ENGLISH
CONTENTS
1. INTRODUCTION TO THE INSTRUCTION MANUAL ........... 2
1.1 Meaning of the symbols used ................................... 2
2. SAFETY RECOMMENDATIONS .................................. 4
2.1 Installer safety .................................................... 4
2.2 Transport and storage ............................................ 4
2.3 Unpacking and handling ........................................ 5
Vent closure ....................................................... 5
2.4 Disposal of the product .......................................... 5
3. 400 .................................................................... 6
3.1 Intended use ...................................................... 6
3.2 Limitations of use ................................................. 6
3.3 Unauthorised use ................................................. 6
3.4 Emergency use .................................................... 6
3.5 Product identification ............................................ 6
Markings on the product ........................................ 6
3.6 Technical characteristics ......................................... 7
3.7 Component identification ....................................... 9
Components supplied ........................................... 9
3.8 Dimensions ........................................................ 9
3.9 Manual operation................................................10
Releasing the actuator ..........................................10
Reinstating operation ..........................................10
4. INSTALLATION REQUIREMENTS .............................. 11
4.1 Mechanical requirements .......................................11
4.2 Electrical system .................................................11
4.3 Example system..................................................12
5. INSTALLATION ................................................... 12
5.1 Determining the position of the rear bracket ................13
5.2 Installing the rear bracket ......................................15
Steel pillar ........................................................15
Masonry pillar with plate to embed ...........................15
Masonry pillar with screw-on plate ............................15
5.3 Installing the fork and joint .....................................16
Installing the rear fork ..........................................16
Connect the joint to the rod ....................................16
5.4 Installing the actuator...........................................16
5.5 Installing the casing .............................................17
5.6 Installing the power cable ......................................17
6. START-UP.......................................................... 18
6.1 Remove the breather screw ....................................18
6.2 Adjusting the force (By-Pass) ...................................18
7. PUTTING INTO SERVICE ........................................ 19
7.1 Final checks ......................................................19
7.2 Final operations .................................................. 19
8. ACCESSORIES ..................................................... 19
9. MAINTENANCE ................................................... 20
9.1 Scheduled maintenance ........................................20
9.2 Operational problems ...........................................21
10. INSTRUCTIONS FOR USE ..................................... 21
10.1 Safety recommendations......................................21
10.2 Emergency use .................................................22
10.3 Manual operation ..............................................22
Releasing the actuator ..........................................22
Reinstating operation ...........................................22
TABLES
1 Technical data .....................................................7
2 Measurements 400 ............................................. 13
3 Measurements 400 L ............................................ 14
4 Scheduled maintenance of the actuator ..................... 20
5 Maintenance of other components .......................... 20
6 Troubleshooting................................................. 21
7 Limitations of use 400 CBC, 400 CBAC, 400 SB ............. 23
8 Limitations of use 400 CBAC L ................................. 23
9 Limitations of use 400 SBS ..................................... 24
10 Limitations of use 400 SBS L ................................... 24
11 Outward opening - Measurements 400 ..................... 25
12 Outward opening - Measurements 400 L ................... 26
ADDENDUM
1 Limitations of use in relation to wind ......................... 23
2 Outward opening applications ................................ 25