1
2
400 5 732871 - Rev. D
1
2
3
4
6 5
7
3
M 4 x 20 ISO4762
Translation of the original instructions
ENGLISH
1 400
2 Carter e relativi fissaggi
3 Supporto per condensatore
4 Condensatore di spunto
5 Accessori di installazione
6 Cavo di alimentazione
7 Manuale istruzioni
2.3 UNPACKING AND HANDLING
RISKS
PERSONAL PROTECTIVE EQUIPMENT
1. Open the package and remove the contents.
2. Check that all components are present and intact.
3. Dispose of the packaging materials.
!
The packaging materials (plastic, polystyrene etc.) must not be left within
reach of children as they are potential sources of danger.
When you have finished with them, dispose of the packaging in the appropri-
ate containers, as per applicable waste disposal regulations.
VENT CLOSURE
!
The 400 is supplied with the vent hole closed with a screw and washer. When
handling the actuator, the vent hole should be closed to prevent oil leaks
(2).
2.4 DISPOSAL OF THE PRODUCT
1 400
2 Casing
3 Capacitor support
4 Capacitor
5 Installation accessories
6 Power cable
7 Instruction manual
After having dismantled the product, dispose of it in compliance with
the current waste disposal regulations.
Components and structural materials, batteries and electronic components
must not be disposed of together with household waste. They must be taken
to authorised disposal and recycling centres.
The oil must be gathered in a watertight container and given to an authorised
disposal and recycling centre. Do not mix with other substances such as
antifreeze or transmission fluids. Keep the used oil away from sources of
heat and out of the children's reach. The fluid is not hazardous to health. In
case of contact with eyes, skin or clothing, wash and rinse the affected parts.
The technical data sheets of the fluids are available in the on-line spare parts
catalogue.
Vent closure
To Next Page
Loading...
Need help?
General
