23
24
746 E R 19 732099 - Rev.D
5
10
5
1
2
6.5 x 18 x 2 UNI 6953
TE 6.3 x 25 UNI 6950
Translation of the original instructions
ENGLISH
NYLON RACK
Rack thickness: 20 mm for leaves weighing up to 400 kg max.
1. Close the leaf manually.
2. Rest an element of the rack on the pinion (23). Make sure that it
is horizontal using a spirit level.
3. Drill holes at the centre of the slots (1). Fasten using suitable screws
and washers.
!
Use fixing screws that are specific for the material from which the leaf is
made. Self-tapping screws and washers are available for aluminium or steel
and should be ordered separately (2).
4. Move the leaf manually. Assemble the next interlocking element at
the end of the previous one and rest it on the pinion (24). Make
sure that it is horizontal using a spirit level.
5. Drill holes at the centre of the slots. Fasten using suitable screws
and washers.
6. Repeat steps 4 and 5 for all elements of the rack that are required for
the length of the leaf.
- If an element needs to be shortened, cut it with an angle grinder
away from the slot.
To Next Page
Loading...
