FAAC 746 E R Z20 - Installing the Cable Glands; Installing the Board Cover

39
40
746 E R 26 732099 - Rev.D
7 33
21
5
4
4
5
3
3
1
1
1
Translation of the original instructions
ENGLISH
7.4 INSTALLING THE CABLE GLANDS
1. Remove the sheath in order to separate the individual wires.
2. With reference to 39, position elements 1 and 2 (with the slot of
each inserted in the pin). Arrange the wires on the rubber strip.
3. Tighten the two elements and fasten them using the screws 3 and
the nuts 4.
4. Fasten to the surface using the screws 5.
Screw seat
Slot
Pin
7.5 INSTALLING THE BOARD COVER
F
The board cover must be installed before switching on the power supply.
1. Install the cover (40). Temporarily remove the thrust capacitor in
order to make this easier.
2. Make sure that the individual cables pass through the dedicated
openings, then push the cover fully onto the 3 retainers (1).