FAAC 746 E R Z20 - Radio Receiver;Decoder Board; Earthing the Gearmotor; Power Cable

38
37
746 E R 25 732099 - Rev.D
J7
NL
PE N L
PENL
J2
Translation of the original instructions
ENGLISH
RADIO RECEIVER/DECODER BOARD
!
Always disconnect power from the board before installing/removing the
receiver/decoder board.

Install a FAAC 5-pin radio receiver board or a decoder board that is compatible,
in terms of frequency and coding technology, with the FAAC radio controls
that are used:
- a single-channel system only enables the OPEN A radio command
- a two-channel system enables the OPEN A and OPEN B/CLOSE radio com-
mands (according to the programmed operating logic).
Insert the radio receiver or the decoder board into the quick insertion
connector J2. The connector is polarised, therefore make sure that
it is inserted the correct way round (37).
EARTHING THE GEARMOTOR
F
Cut the power to the system before making the connections.
1. Crimp the earthing conductor of the mains power cable and a similar
cable, approximately 20 cm long, onto the cable lug (provided in
the hardware/accessories) (38).
2. Fasten the cable lug to the earth connection of the gearmotor using
the nuts and washer provided with the hardware/accessories.
3. Connect the free end of the cable to the earth terminal on the board.
POWER CABLE
F
Cut the power to the system before making the connections.
Connect the phase wire to terminal L and the neutral to terminal N
of J7 (38).
Terminal board J7
PE Earth
N Neutral
L Phase
Example: RP2