FAAC 746 E R Z20 - 7 Electronic Installation; Removing the Cover from the Board; Board 780 D; Components

32
33
746 E R 22 732099 - Rev.D
8.8.
OPEN A
OPEN B
FSW OP
FSW CL
STOP
SAFE
TX-FSW
W.L.
24 V

500 mA
max
60 W max
123456789101112
{
NL
PE N L
PENL
17 16 1415 13
M
L N
MOT COM
MOT1 MOT2
CAP
LAMP
F2
Led
F - +
F1
display
J6
J5
J3
J7
J1
J2
J9
J8
J4
SAFE
FSW OP
OPEN A
FSW CL
FC1
FC2
OPEN B
STOP
Translation of the original instructions
ENGLISH
7. ELECTRONIC INSTALLATION
RISKS
PERSONAL PROTECTIVE EQUIPMENT
7.1 REMOVING THE COVER FROM THE BOARD
F
Only remove the board cover in order to work on electrical connections. Dis-
connect the power supply to the automation before removing the cover of the
electronic board. Only reconnect the power supply after having reinstalled
the cover.
The board must be programmed with the board cover installed.
Remove the casing cover and lift the board cover (33). Temporarily
remove the thrust capacitor in order to make this easier.
COMPONENTS
J1
Removable terminal board for control devices and accessories (provided in the
hardware/accessories)
J2 Connector (5-pin) for radio/decoder boards (as indicated in the FAAC catalogue)
J3-J4 Transformer connectors
J5 Rapid connector for start-up capacitor
J6 Removable terminal board for motor and flashing light
J7
Removable terminal board for mains power supply (provided in the hardware/
accessories)
J8 Rapid connector for inductive limit switch
J9 Rapid connector for magnetic limit switch
F1 Fuse for mains power supply F 5 A (230 V~) F 10 A (115 V~)
F2 Fuse for accessories power supply T 0.8 A
+ - F Programming buttons
STATUS LEDS
FC1 FC2 Opening/closing limit switch (depending on the opening direction)
SAFE Sensitive edges
STOP STOP command
FSW CL Closing photocells
FSW OP Opening photocells
OPEN B Partial opening/closing command
OPEN A Total opening command
ENCODER Encoder
7.2 BOARD 780D