FAAC 746 E R Z20 - Installing the Cover; 6 Optional Equipment; Release Lock with Personalised Key

30 31
29
746 E R 21 732099 - Rev.D
24
24
8
8
8
1
Translation of the original instructions
ENGLISH
6. OPTIONAL EQUIPMENT
6.1 RELEASE LOCK WITH PERSONALISED KEY
1. Open the release lever using the key. Remove the screw and the
locking lever, then remove the nut and the existing lock (30).
2. Install the new lock and fasten it using the nut. Insert the locking
lever vertically and fasten it using the screw (31).
3. Make sure that the release lever works, using the new keys.
5.6 INSTALLING THE COVER
!
The cover protects the electronic components and prevents access to moving
parts. Never leave the gearmotor unattended without the cover fitted until
installation has been completed.

Install the cover once the gearmotor has been set-up.
With reference to 29, apply the adhesive sign 1 to the cover: risk
of fingers and hands being trapped due to the rotation of the pinion
and the movement of the rack. Install and fasten the cover. Press
the screw caps on.