FAAC 746 E R Z20 - Adjusting and Checking; Fastening the Gearmotor Permanently

26
27 28
25
746 E R 20 732099 - Rev.D
19
80
Nm
3 mm
=
=
!
A
!
B
180°
19
Translation of the original instructions
ENGLISH
5.4 ADJUSTING AND CHECKING
1. In order for it to work correctly, the rack must never rest on the
pinion. Turn all the support nuts clockwise by half a turn (25)
in order to lower the gearmotor. In this way, a constant distance
between pinion and rack is obtained for the entire length of
travel (26-A). Make sure that the gearmotor is level by using
a spirit level.
2. Check: when the distance between rack and pinion is correct, with
the gearmotor stopped, it is possible to rock the leaf manually to
the left and right by a few millimetres.
3. Make sure that the rack is centred on the pinion (26-B).
Move the leaf manually to repeat the checks along the entire length
of travel for all the elements of the rack.
!
Comply with the safety information § Manual operation.
5.5 FASTENING THE GEARMOTOR PERMANENTLY
1. Tighten the upper nuts to the fastening torques indicated in the
figure (27).
2. Press the guards onto the brackets (28).