FAAC E145 - BUS-2 EASY Encoder Setup

E145 13 732784 - Rev. A
DL 2
DL 1
DL 2
DL 1
DL 2
DL 1
DL 3
DL 2
DL 1
DL 3
ENGLISH
BUS-2EASY encoder
BUS-2EASY encoder connection is done using the bi-polar cables supplied with.
Connection - Address assignment of BUS-2EASY Encoder
The polarity of the BUS-2EASY line connection determines the correspondence of the
encoder to one leaf or the other.
pay careful attention to the indications of the status LEDs located on the body of each
encoder.
LEAF 1 opens first and closes last.
1 LED on.
On leaf 1 check that, with the
motor stopped, LEDs DL1 and
DL2 are on.
On leaf 2 check that, with the
motor stopped, LED DL1 is on.
Encoder
Cable Inversion
Encoder
Leaf 1
Encoder
Leaf 2
On leaf 1 check that, with the
motor stopped, LEDs DL1
and DL2 are on.
2 LEDs on.
2 LEDs on.
1 LED on.
Note: by inverting the encoder wires, this will
switch around the encoder associated with
leaf 1 and the encoder associated with leaf 2
and vice versa.
On leaf 2 check that, with the
motor stopped, LED DL1 is on.
LEAF 2
LEAF 1
LEAF 1
LEAF 2