FAAC E145 - TROUBLESHOOTING

E145 41 732784 - Rev. A
ENGLISH
9. TROUBLESHOOTING
Description Solution
A
The board does not turn on
• Ensure that the board is receiving the 230V~
• Ensure that fuse F1 is intact
B
The gate will not open after
an OPEN pulse
• Check that the safety devices and STOP are connected
to the negative and ensure that the corresponding LEDs
are ON
• Check the photocells (alignment, engagement)
• Check that the SETUP has been completed correctly.
Repeat if necessary
C
The gate does not reverse
when the photocells are
engaged
• Check that the traditional photocells are correctly wired and
that the BUS photocell configuration is correct (if present).
If necessary, repeat the acquisition of the BUS-2EASY
devices
D
The gate does not reverse
when encountering
an
obstacle
• Ensure that the encoders on motors are enabled
• Check the obstacle detection sensitivity
E
The gate will not close
• Check that the photocell wiring and alignment is correct
• Check that there is no OPEN signal active
• Check which function logic has been chosen (automatic
or semi-automatic)