E145 37 732784 - Rev. A
ENGLISH
6.4 DELETING THE RADIO CONTROLS
This operation CANNOT be reversed. This will delete ALL the radio control codes me-
morised as both OPEN A and OPEN B/CLOSE. The cancellation procedure is active only
in gate status visualisation mode.
1. Press and hold -/R2
-/
R2
.
2. After pressing for about 5 sec, the DL12 LED begins to flash slowly; after another 5 sec of slow flashing
and holding, the LEDs DL11 and DL12 begin flashing more rapidly (cancellation has started).
3. Once rapid flashing has stopped, LEDs DL11 and DL12 will go on steady, confirming the cancellation
of all the radio codes (OPEN A and OPEN B/CLOSE) from the board memory.
4. Release -/R2
-
/
R2
. The LEDs will go off, indicating correct cancellation.
To Next Page
Loading...
