E145 5 732784 - Rev. A
ENGLISH
CONTROL BOARD E145
We thank you for having chosen one of our products. FAAC is certain that from it you will obtain
all the performance you require. All our products are the result of years of experience in the field of
automated systems.
Mains primary power supply
With power supply switching from 90 V~ to 260 V~; 50/60Hz
Power absorbed from mains
stand By = 4W sleep < 2 W
*
MAX ~ 800 W
*
FUNCTION THAT CAN BE ENABLED FROM A PC/MAC
MAX load for motors
800 W
Accessories power supply
24 V
"
MAX. accessories current
+24V MAX 500 mA BUS-2EASY MAX 500 mA
LOCK (FAAC) 12 V~ / 24 V
"
LOCK (not FAAC) 24 V
"
500mA (3A peak)
Operating ambient temperature
from -20°C to +55°C
Power supply safety fuses
F1 = F10AH250V
Work time
Self-learned through SETUP
- (Max 4 min and 10 sec)
Pause time
Programmable (from 0 to 9 min and 50 sec)
Motor power
Programmable on 50 levels
Connector inputs
Decoder/Minidec/RP, X-COM, XF433/868 Module, USB-
A, USB-B
T
erminal board inputs
Mains power supply
from 90 to 260V ~, Inputs from IN1 to
IN5, Limit switch, BUS-2EASY
Terminal board outputs
Flashing lamp, Motors, Electric lock (LOCK1 and LOCK2),
OUT1 and OUT2 (programmable),
Accessories power supply
1. TECHNICAL SPECIFICATIONS
PURPOSE: this electronic control board has been
designed and built to control swing-leaf and/or
sliding gates for vehicle and pedestrian access
control.
Thanks to the innovative power supply switching
system, the board is able to automatically adapt
to different input voltages (from 90V~ to 260V~),
maintaining constant the output value of accesso-
ries, without being affected by variations.
During programming you can choose between
different function logics.
2 programming levels are available from the bo-
ard (BASIC and ADVANCED), using buttons and
LCD display.
This board also allows you the programming using
PC or MAC, connected via USB-B or X-COM
module.
Tab. Technical specifications
To Next Page
Loading...
