E145 34 732784 - Rev. A
2” x 2
OK
>5”
OPEN A
2” x 2
OK
>5”
OPEN B
<5”
<5”
ENGLISH
6. MEMORISING THE RADIO CODE
The control board features an integrated 2-channel decoding system (DS, SLH/SLH LR, RC) called
OMNIDEC. This system lets you memorise, using an additional receiver module (on J5 connector)
and more radio controls having different technology
but the same frequency. You can thus control
both total opening (OPEN A) and partial opening (OPEN B).
The different types of radio code (DS, SLH/SLH LR, LC/RC) can coexist simultaneously
on the two channels. You can enter up to 1600 radio codes divided between OPEN A
and OPEN B/CLOSE.
To use different encoding systems on the same channel, you must complete the learning of
each encoding system and then repeat the procedure for the other one.
Other
, more detailed, programming options are available using a PC/MAC (see dedicated
PC/MAC instructions). For example, you can set an automatic OPEN command on the radio
channel to command an automatic cycle (open-pause-close) regardless of the selected logic.
6.1 MEMORISING THE SLH/SLH LR RADIO CONTROLS
1.
Press and hold +/R1 - SW1 (OPEN A programming) or -/R2 - SW2 (OPEN B/CLOSE programming).
2. After keeping the button pressed for about 5 sec, the corresponding radio LED (DL11 or DL12) will
begin to flash slowly for about 20 sec.
3. Release the button.
4. Simultaneously press and hold P1 and P2 on the SLH/SLH LR radio control (only MASTER radio
control).
5. The radio control LED will begin to flash.
6. Release both buttons.
7.
Ensure that LED DL11 or DL12 on the board is still flashing (see point 2) and, while the radio control
LED is still flashing, press and hold the desired button on the radio control (the radio control LED
will go on steady).
8. The corresponding LED on the board (DL11 or DL12) will go on steady for 1 sec and then go off,
indicating that memorisation has been completed.
9. Release the radio control button.
10. To complete memorisation, press the button of the memorised radio control twice in succession. The
automated system will perform an opening cycle.
Ensure that there are no obstacles (by people or things) during the automated system
movement.
OPEN A
TOTAL OPENING
OPEN B
PARTIAL OPENING
To Next Page
Loading...
