E145 14 732784 - Rev. A
RADIO XF 433-868
RADIO 1
DL12
DL11
RADIO 2
J5
J4
RP/DEC
CONNECTIVITY
ENGLISH
LED ON FLASHING OFF
DL1
Power present
Communication present
Power present
Communication absent
Power absent
Communication absent
DL1 must always be on to confirm correct encoder/board connection.
DL2
Leaf 1 / Leaf 2
DL2 indicates the leaf on which the encoder is installed; it must be on for leaf 1 and off for
leaf 2.
DL3
Stationary leaf Leaf in motion Stationary leaf
DL3 indicates pulse reading during leaf movement using steady flashing. In stationary status
of the leaf, the DL3 can be either on or off.
In case of incorrect connection (DL2 on or off for both of the encoders), during the
BUS-2EASY accessories learning procedure, the DL1 leds of both encoders are
FLASHING.
Tab. BUS-2EASY Encoder LEDs Status
4.7 J5 - XF MODULE RAPID CONNECTOR
Plug-in rapid connector dedicated to OMNIDEC
2-channel decoding module.
ALWAYS cut off power to the board BE-
FORE inserting/removing the module.
4.8 J14 - DECODER/MINIDEC/RP RAPID CONNECTOR
Rapid connector dedicated to Decoder/Minidec/RP/RP2.
Connect the accessory with the components facing inside the board.
ALWAYS cut off power to the board BEFORE inserting/removing plug-in boards.
The RP2 2-channel receiver lets you control two different radio channels of the automated system
(OPEN A and OPEN B/CLOSE) using a 2-channel radio control.
The 1-channel receiver (Decoder/Minidec/RP) lets you control only one radio channel: OPEN A.
Other programming options are available by programming via a PC/MAC (see dedicated
instructions).
4.9 M1A - X-COM MODULE RAPID CONNECTOR
Plug-in connector dedicated to X-COM, G-COM, WI-COM, Net-COM modules.
ALWAYS cut off power to the board BEFORE inserting/removing the module.
Other programming options are available by programming via a PC/MAC (see dedicated
instructions).
To Next Page
Loading...
