Remote modules
CNC 8060
CNC 8065
6.
(REF: 1402)
·109·
REMOTE MODULE RIOR. (CANOPEN PROTOCOL).
Mounting the module.
The RIOR module may be mounted onto the electrical cabinet in two positions; parallel to
the cabinet with 4 mounting points or perpendicular to it with two mounting points. Use M6
bolts to secure the modules.
Connection of the modules.
Join the ground terminal of the module to the cabinet chassis. Each module is connected
to the system (central unit, keyboard, etc.) through the CAN bus as described later on.
To Next Page
Loading...
