Fagor CNC 8060 - Technical and Electrical Characteristics

·66·
Remote modules
CNC 8060
CNC 8065
5.
(REF: 1402)
RIOW REMOTE MODULES. (CANOPEN PROTOCOL).
5.2 Technical and electrical characteristics.
5.2.1 Technical characteristics.
Mechanical characteristics.
Vibrations (module RIOW-CANOPEN-ECO).
• Meets the IEC60068-2-6 standard.
• Sweep sine trial with a frequency step of 1 octave/minute (±10%) and 10 sweeps long
per axis, on each of the three vertical axes.
Vibrations (module RIOW-CANOPEN-STAND).
• Meets the IEC60068-2-6 standard.
• Sweep sine trial with a frequency step of 1 octave/minute (±10%) and on each of the three
axes.
Choques.
• Meets the IEC60068-2-27 standard.
• Semi-sinusoidal pulses with 15g peaks for 11 ms. 3 pulses in each direction (positive and
negative) of each of the three vertical axes (18 pulses in all).
Free fall.
• Meets the IEC60068-2-32 standard.
• Up to 1 m with the unit in its original packaging.
Electromagnetic compatibility.
Regulations valid for all RIOW modules.
Immunity against disturbances (regulation EN 50082-2:1996).
• Meets the EN 61000-4-2 regulation.
• Meets the EN 61000-4-3 regulation.
• Meets the EN 61000-4-4 regulation.
• Meets the EN 61000-4-6 regulation.
Regulations valid for all RIOW modules except for RIOW-CANOPEN-ECO and RIOW-
CANOPEN-STAND modules.
Emission of disturbances (regulation EN 50081-1:1993).
• Meets the EN 55022 regulation.
Regulations only valid for all RIOW-CANOPEN-ECO and RIOW-CANOPEN-STAND
modules.
Emission of disturbances (regulation EN 50081-2:1994).
• Meets the EN 55011 regulation.
10 Hz  f < 57 Hz Constant movement with an amplitude of 0.075 mm.
57 Hz  f < 150 Hz Constant 1g acceleration.
5 Hz  f < 9 Hz 1.750 mm amplitude (constant) or 3.5 mm (short periods).
9 Hz  f < 150 Hz 0.5 mm (constant acceleration) or 1g (short periods).