Fagor CNC 8060 - Numbering of the Digital Inputs and Outputs

·42·
Remote modules
CNC 8060
CNC 8065
3.
(REF: 1402)
RIO70 REMOTE MODULES. (CANFAGOR PROTOCOL).
3.9 Numbering of the digital inputs and outputs.
Use machine parameters to set the number of digital I/O modules connected to the same
CAN bus. If these parameters are not set, the CNC numbers the modules automatically
according to the order of the remote groups (·ADDRESS· selector of the power supply
module).
Numbering according to the order of the remote groups.
The CNC numbers the modules automatically according to the
order of the remote groups (·ADDRESS· selector of the power
supply module). Within each group, they are ordered from top to
bottom and from left to right.
POWER SUPLY
Example of configuration of the following remote modules.
Group ·1· Group ·2· Group ·3·
48 digital inputs. 16 digital inputs. 32 digital inputs.
32 digital outputs. 16 digital outputs. 16 digital outputs.
Example 1.
Group ·1·
(address = 1)
Group ·2·
(address = 2)
Group ·3·
(address = 3)
Digital inputs. 1 ·· 48 49 ·· 64 65 ·· 96
Digital outputs. 1 ·· 32 33 ·· 48 49 ·· 64
Example 2.
Group ·1·
(address = 1)
Group ·2·
(address = 3)
Group ·3·
(address = 2)
Digital inputs. 1 ·· 48 81 ·· 96 49 ·· 80
Digital outputs. 1 ·· 32 49 ·· 64 33 ·· 48
GROUP = 1
POWER SUPLY
DIGITAL OUTPUT
O48
DIGITAL INPUT
O33
I64
I49
GROUP = 2
POWER SUPLY
DIGITAL OUTPUT
DIGITAL INPUTDIGITAL INPUT
O16
DIGITAL OUTPUT
O1
O32
O17
DIGITAL INPUT
I48
I33
I16
I1
I32
I17
GROUP = 3
POWER SUPLY
DIGITAL OUTPUT
DIGITAL INPUT
O64
DIGITAL INPUT
O49
I80
I65
I96
I81
GROUP = 1
POWER SUPLY
DIGITAL OUTPUT
O64
DIGITAL INPUT
O49
I96
I81
GROUP = 2
POWER SUPLY
DIGITAL OUTPUT
DIGITAL INPUTDIGITAL INPUT
O16
DIGITAL OUTPUT
O1
O32
O17
DIGITAL INPUT
I48
I33
I16
I1
I32
I17
GROUP = 3
POWER SUPLY
DIGITAL OUTPUT
DIGITAL INPUT
O48
DIGITAL INPUT
O33
I64
I49
I80
I65