Fagor CNC 8060 - RIOW-8 DO Module. Module of 8 Digital Outputs

Remote modules
CNC 8060
CNC 8065
5.
(REF: 1402)
·95·
RIOW REMOTE MODULES. (CANOPEN PROTOCOL).
5.9 RIOW-8DO module. Module of 8 digital outputs.
Expansion module with eight 24V DC 0,5 A digital outputs. The module has an LED indicating
the status for each output.
The 24 V DC needed to power the module comes from the previous module (inputs, outputs
module or power supply module) through the side power supplying jumpers). Likewise, this
module can also power the next module through the same jumpers. This module, by itself,
does not generate any voltage; it just receives the voltage generated by the previous RIOW-
PS24 module and passes it on to the next module.
48
15
26
37
A
B
C
D
E
F
G
H
Digital output ·3·.
Digital output ·5·.
Digital output ·7·.
Digital output ·1·.
Digital output ·4·.
Digital output ·6·.
Digital output ·8·.
Digital output ·2·.
LED's indicating the activity of
the digital outputs.
Jumpers to power the next module.Jumpers to power the module.