Fagor CNC 8060 - Installation of the Modules

Remote modules
CNC 8060
CNC 8065
7.
(REF: 1402)
·117·
REMOTE MODULE RCS-S. (SERCOS PROTOCOL)
7.1 Installation of the modules.
Place the modules on 2 profiles, according to the UNE 50022 standard, with 2 securing ends,
one at each end of the group; they help securing the modules besides maintaining the right
gap between the profiles.
Dimensions of the modules.
Always leave a 140 mm gap under the modules for ventilation and later handling.
Connection of the modules.
Each module is connected to the system via the Sercos bus. The Sercos connection is
carried out in a ring using fiber optic cable by joining an OUT terminal with an IN terminal.
DO NOT make any connection or connect any module or cable if the group is under power. Before
connecting anything, unplug the cable from the power supply module.
DO NOT make any connection or connect any module to the power supply while the latter is turned
on. Before making any connection, turn the power supply off by unplugging the power cable.
OUT
IN
CNC Node n
OUT
IN
OUT
IN
OUT
IN
OUT
IN
Node n-1Node 1 Node 2 ...