Fagor CNC 8060 - Page 34

·34·
Remote modules
CNC 8060
CNC 8065
3.
(REF: 1402)
RIO70 REMOTE MODULES. (CANFAGOR PROTOCOL).
3.4.1 Elements (connectors).
Connector ·X1· & ·X2·. Digital inputs (8 inputs in each connector).
10-pin male Phoenix minicombicon contact (3.5 mm pitch).
Connector ·X1· & ·X2·. Digital outputs (8 outputs in each connector).
10-pin male Phoenix minicombicon contact (3.5 mm pitch). Both connectors must be
powered with 24 V DC and GND.
Status indicator LED.
The green LED located in the middle of the digital output module turns on when the module
is powered with 24 Vdc and the inside fuse is OK.
Signal. Function.
N.C. Not being used.
I1 - I8 Digital inputs.
I9 - I16 Digital inputs.
GND 0 V reference signal.
I1
N.C.
GN D
I8
I2
I3
I4
I5
I6
I7
I9
N.C.
GN D
I16
I10
I11
I12
I13
I14
I15
Signal. Function.
+ 24 V Power supply.
O1 - O8 Digital outputs.
O9 - O16 Digital outputs.
GND 0 V reference signal.
O1
+24V
GN D
O8
O2
O3
O4
O5
O6
O7
O9
+24V
GN D
O16
O10
O11
O12
O13
O14
O15