Remote modules
CNC 8060
CNC 8065
5.
(REF: 1402)
·69·
RIOW REMOTE MODULES. (CANOPEN PROTOCOL).
Analog inputs for PT100 temperature sensors.
Each input has 2 LED's; a green one that turns on when the bus transmission is OK and a
red one that turns on when there is a reading error at the inputs.
The inputs are protected by opto-couplers. Use shielded cables connecting their meshes to
the corresponding shield pin. Maximum cable length (unshielded): 75 mm.
Technical characteristics.
Number of inputs. 2 inputs per module.
Type of sensor. PT100
Type of connection. 2-wire or 3-wire interface.
Temperature range. Between -200 ºC ( -328 ºF) and +850 ºC (1562 ºF).
Resolution. 0.1 ºC
Measuring error (25 ºC). <± 0.2 %
Response time, from when the sensor is
connected until the first correct measure is
obtained.
4 s.
Typical consumption of each input. 0.5 mA.
To Next Page
Loading...
